A player that has the ball is limited in how they can move. They can only run if they are dribbling the ball (bouncing it with one hand) and once they finish dribbling they cannot start dribbling again. When they have the ball and are standing still a player may step with one foot, which enables them to change direction (e.g. to move away from a defender).

Pivoting is when a player stands still and steps with one foot . The foot that stays on the ground is called the pivot foot. To determine which foot is the pivot foot:

  • If the player caught the ball with one foot on the ground – that foot is the pivot foot;
  • If the player caught the ball with two feet on the ground – they may choose which foot to pivot on but once they make that decision they cannot then pivot on the other foot;
  • If the player catches the ball in the air – whichever foot lands first is their pivot foot. If both feet land at the same time (a “jump stop”), the player may choose which foot to pivot on.

The pivot foot is important because:

  • A player must start dribbling the ball before lifting their pivot foot;
  • A player may lift their pivot foot as long as they pass or shoot prior to the foot being put back on the ground.

There are three common mistakes that players make when pivoting:

  • They twist only the top half of their body instead of stepping with their feet (i.e. they are not pivoting but they should be);
  • They stand with legs straight, which means that they have little balance;
  • They bend down (looking at the floor) which both affects their balance but also makes it hard for them to see open team mates.

A pivot should be a controlled, balanced move performed with legs bent so that the player has good balance. A player can pivot either forwards or backwards (a backward pivot is also called a “drop step”) and before pivoting backwards they should move their chin to their shoulder so that they can see behind them and ensure that they are not moving into trouble.

In 2017, the rules were changed in relation to a player catching the ball whilst on the move (either from a pass or to end their dribble). This change has been described as a “zero step” or a “gather step” and applies in limited situation.

CASE 1: PROGESSING PLAYER / STOP-SHOOT-PASS

After getting possession of the ball on the move (progressing) a player can now take two steps before stopping, shooting or passing

When the ball is gathered/received when one foot touching the floor (upon dribble or after pass while progressing),
NEXT foot (AFTER gather) to touch the floor is first step (diagram 1).

When the ball is gathered/received both feet in the air, NEXT foot to touch the floor is first step (pivot foot – diagram 2).

CASE 2: PROGRESSING PLAYER / STAR DRIBBLING

However, if player wanted to start dribble while progressing, the ball must be released before 2nd Step.

When the ball is received when one foot touching the floor while progressing, NEXT foot (AFTER receiving the ball) to touch the floor is 1st step and the ball must be released before 2nd step (in example left foot touches the floor) to start dribble (diagram 3).

When the ball is received in the air, NEXT foot to touch the floor is 1st step (pivot foot) and the ball must be released before 2nd step (in example left foot touches the floor) to start dribble.